RoomTask is a simple room-entry task reminder built around an Arduino UNO R4 Minima, a PIR motion sensor, and a 16×2 I²C LCD.
When the PIR sensor detects a new motion event, RoomTask displays the saved reminders on the LCD. Tasks are entered over the Arduino USB serial connection and are kept in RAM for the current power session.
- Detect a motion event with a PIR sensor.
- Display reminders on a 16×2 I²C LCD.
- Add, list, and clear reminders through the USB Serial Monitor.
- Keep reminders in temporary RAM storage.
- No Bluetooth, RTC, date/time scheduling, or persistent storage in this version.
firmware/RoomTask/RoomTask.ino— Arduino sketch.hardware/README.md— wiring notes and provisional pin configuration.docs/ARCHITECTURE.md— v0.1 design and behavior.docs/SERIAL_COMMANDS.md— Serial Monitor command reference.
- Arduino UNO R4 Minima
- PIR motion sensor with a digital output
- 16×2 LCD with an I²C backpack
- Arduino IDE or Arduino CLI
- A compatible
LiquidCrystal_I2Clibrary
- Review hardware setup and confirm the pin assignments match your wiring.
- Install a compatible
LiquidCrystal_I2Clibrary in the Arduino IDE. - Open
firmware/RoomTask/RoomTask.ino. - Select Arduino UNO R4 Minima and the correct USB port.
- Upload the sketch.
- Open Serial Monitor at 115200 baud and set the line ending to Newline.
- Enter
HELPto see the available commands.
Example:
ADD Water the plants
ADD Check the desk
LIST
The reminders are lost when the board resets or loses power.
This is the initial v0.1 scaffold. Hardware has not been verified and the sketch has not yet been compile-tested on a physical UNO R4 Minima. Confirm the LCD I²C address and wiring before use.
MIT — see LICENSE.